Inspection Procedure
WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK CONNECTOR
- Turn the ignition switch OFF.
- Disconnect the battery cable from the negative terminal.
- Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side).
- Harness connector M1
- Harness connector E30
Is the inspection result normal?
YES: GO TO 2.
NO: Repair the terminal and connector.
- CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
- Disconnect the harness connectors M1 and E30.
- Check the continuity between the data link connector and the harness connector.
CONTINUITY SPECIFICATIONData link connector Harness connector Continuity Connector No. Terminal No. Connector No. Terminal No. M22 6 M1 15G Existed 14 8G Existed Is the inspection result normal?
YES: GO TO 3.
NO: Repair the main line between the data link connector and the harness connector M1.
- CHECK HARNESS CONTINUITY (OPEN CIRCUIT)
- Disconnect the connector of ABS actuator and electric unit (control unit).
- Check the continuity between the harness connector and the ABS actuator and electric unit (control unit) harness connector.
CONTINUITY SPECIFICATIONHarness connector ABS actuator and electric unit (control unit) harness connector Continuity Connector No. Terminal No. Connector No. Terminal No. E30 15G E26 26 Existed 8G 15 Existed Is the inspection result normal?
YES (Present error): Check CAN system type decision again.
YES (Past error): Error was detected in the main line between the data link connector and the ABS actuator and electric unit (control unit).
NO: Repair the main line between the harness connector E30 and the ABS actuator and electric unit (control unit).