LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 994 (LAN System) >> Can >> Component Diagnosis >> DLC Branch Line Circuit >> Diagnosis Procedure >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK CONNECTOR
    1. Turn the ignition switch OFF.
    2. Disconnect the battery cable from the negative terminal.
    3. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side).

    Is the inspection result normal? 

    YES: GO TO 2.

    NO: Repair the terminal and connector.

  2. CHECK HARNESS FOR OPEN CIRCUIT

    Check the resistance between the data link connector terminals.

    RESISTANCE SPECIFICATION

    Data link connector Resistance (Ω)
    Connector No. Terminal No.
    M22 6 14 Approx. 54 - 66

    Is the measurement value within the specification? 

    YES (Present error): Check CAN system type decision again.

    YES (Past error): Error was detected in the data link connector branch line circuit.

    NO: Repair the data link connector branch line.

scientia non olet · About LEMON Manuals