LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 992 (Seat Belts) >> On-Vehicle Repair >> Front Seat Belt >> Removal and Installation >> Removal Of Seat Belt Retractor

Removal Of Seat Belt Retractor

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Before servicing SRS, turn the ignition switch off, disconnect both negative and positive battery terminals, then wait at least 3 minutes.
  1. Disconnect both negative and positive battery terminals, then wait at least 3 minutes.
  2. Release the pawl, then remove lower anchor bolt cover and lower anchor bolt.
  3. Remove center pillar lower and upper finishers. Refer to "REMOVAL AND INSTALLATION ".
  4. Remove D-ring anchor bolt from adjustable upper anchor.
  5. Remove seat belt retractor assembly.
    • Disconnect the seat belt pre-tensioner harness connector.
      CAUTION:
      • For installing/removing seat belt pre-tensioner harness connector, insert a thin screwdriver wrapped with tape into the notch; lift locking tab then remove connector.
      • Install connector with lock raised, then push locking tab into connector.
      Fig 1: Disconnecting Seat Belt Pre-Tensioner Harness Connector
      G04887382Courtesy of NISSAN MOTOR CO., U.S.A.
    • Remove seat belt retractor screw and anchor bolt, then remove seat belt retractor assembly from center pillar.
  6. Remove bolts, then remove adjustable upper anchor from center pillar.
scientia non olet · About LEMON Manuals