Removal and Installation: Notes

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 minutes.
Do not use air tools or electric tools for servicing.
Do not disassemble the spiral cable.
Do not allow oil, grease, detergent or water to come in contact with the spiral cable.
With the steering linkage disconnected, the cable may snap by turning the steering wheel beyond the limited number of turns. The spiral cable can be turned counterclockwise about 2.5 turns from the neutral position.
Do not cause impact to the spiral cable by dropping etc. Replace the spiral cable if it has been dropped or sustained an impact.

Fig 1: Precaution For Handling Spiral Cable

Courtesy of NISSAN MOTOR CO., U.S.A.