LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 991 (SRS Airbag) >> On-Vehicle Repair >> Diagnosis Sensor Unit >> Removal and Installation >> Notes

Removal and Installation: Notes

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least 3 minutes.
  • Before disconnecting the air bag sensor unit harness connector, be sure to disconnect the harness connector of each air bag module and pre-tensioner seat belt to prevent air bag deployment by static electricity.
  • Do not use air tools or electric tools for servicing.
  • Replace the diagnosis sensor unit of deployed SRS air bag and deployed SRS front seat belt pre-tensioner.
  • Do not cause an impact to the diagnosis sensor unit by dropping etc. Replace the diagnosis sensor unit if it has been dropped or sustained an impact.
Fig 1: Precaution For Handling Diagnosis Sensor Unit
G05224522Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals