LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 991 (SRS Airbag) >> On-Vehicle Repair >> Crash Zone Sensor >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative and positive battery terminals, then wait at least 3 minutes.
  2. Remove the air inlet duct, then position upper radiator hose aside.
  3. Disconnect the crash zone sensor harness connector.
  4. Remove the nuts, then remove crash zone sensor.
scientia non olet · About LEMON Manuals