LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 991 (SRS Airbag) >> On-Vehicle Repair >> Crash Zone Sensor >> Removal and Installation >> Installation

Removal and Installation: Installation

WARNING: This page is about a different car, the 2009 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

CAUTION:
  • Do not use old crash zone sensor nuts after removal; replace with new nuts.
  • Be careful not to damage the crash zone sensor harness.
  • After the work is completed, make sure no system malfunction is detected by air bag warning lamp.
  • In case a malfunction is detected by the air bag warning lamp, reset by the self-diagnosis function and delete the memory by CONSULT-III.
  • If a malfunction is still detected after the above operation, perform self-diagnosis to repair malfunctions. Refer to "SRS OPERATION CHECK ".
scientia non olet · About LEMON Manuals