Gap Adjustment
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
If any excessive gap difference between glass lid assembly and roof panel is found, perform the following:
- Open sunshade assembly.
- Tilt glass lid assembly up, then remove side finisher.
- Loosen glass lid assembly screws (2 each on center and right sides), then tilt it down.
- Manually adjust glass lid assembly from outside of vehicle until it is flush with the roof surface and resembles "A-A" as shown.
- After adjustment, tilt glass lid assembly up and tighten screws.
- Tilt glass lid assembly up and down several times to check that it moves smoothly.
NOTE:
First tighten center front screw, then right rear on glass lid assembly to prevent movement while tightening other screws.