Rear Turn Signal Lamp Does Not Operate

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK TAIL LAMPS AND STOP LAMPS
Check bulb standard of each turn signal lamp is correct. Refer to "EXTERIOR LAMP ".

OK or NG

OK: GO TO 2.

NG: Replace turn signal lamp bulb. Refer to "BULB REPLACEMENT ".
CHECK TURN SIGNAL LAMPS CIRCUIT
1. Disconnect BCM connector and rear combination lamp connector.
2. Check continuity between BCM connector M19 (A) terminal 61 and rear combination lamp RH connector B36 (B) terminal 3.
  61 - 3: Continuity should exist.
3. Check continuity between BCM connector M19 (A) terminal 60 and rear combination lamp LH connector B35 (B) terminal 3.
  60 - 3: Continuity should exist.
Fig 1: Checking Continuity Between BCM Connector M19 Terminal 60 And Rear Combination Lamp LH Connector B35 Terminal 3
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 3.

NG: Repair harness or connector.
CHECK GROUND CIRCUIT
Check continuity between rear combination lamp harness connector B35 LH and B36 RH terminal 5 and ground.

5 - Ground: Continuity should exist.

Fig 2: Checking Continuity Between Rear Combination Lamp Connector B35 LH And B36 RH Terminal 5 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Check rear combination lamp connector for proper connection. Repair as necessary.

NG: Repair harness or connector.