Hazard Warning Lamp Does Not Operate But Turn Signal Lamps Operate

Make sure bulb standard of each turn signal lamp is correct. Refer to "EXTERIOR LAMP ".

OK or NG 

OK: GO TO 2.

NG: Replace turn signal lamp bulb. Refer to "FRONT TURN SIGNAL LAMP " for front turn signal bulb. Refer to "BULB REPLACEMENT " for rear turn signal bulb.

With CONSULT-III

Select "BCM" on CONSULT-III. With "FLASHER" data monitor, make sure "HAZARD SW" turns ON-OFF linked with operation of hazard switch.

When hazard switch is in ON position: HAZARD SW ON 

Without CONSULT-III

Check voltage between BCM harness connector M18 terminal 29 and ground.

Fig 1: Checking Voltage Between BCM Connector M18 Terminal 29 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Replace BCM. Refer to "BCM ".

NG: GO TO 3.

1. Turn ignition switch OFF.
2. Disconnect BCM connector and hazard switch connector.
3. Check continuity between BCM harness connector M18 terminal 29 and hazard switch harness connector M202 terminal 2.

   29 - 2: Continuity should exist. 

Fig 2: Check Continuity Between Connector M18 Terminal 29 And Connector M55 Terminal 2

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: GO TO 4.

NG: Repair harness or connector.

Check continuity between hazard switch harness connector M202 terminal 1 and ground.

1 - Ground: Continuity should exist. 

Fig 3: Checking Continuity Between Hazard Switch Connector M55 Terminal 1 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: GO TO 5.

NG: Repair harness or connector.

1. Disconnect hazard switch connector.
2. Check continuity of hazard switch.
   HAZARD SWITCH
   
   

   Hazard switch		Condition	Continuity
   Terminal
   1	2	Hazard switch is pressed	Yes
   		Hazard switch is released	No

   Fig 4: Checking Continuity Of Hazard Switch

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Replace BCM if hazard warning lamps do not work after setting the connector again. Refer to "BCM ".

NG: Replace hazard switch. Refer to "REMOVAL AND INSTALLATION ".