Power Window and Door Lock/Unlock Switch RH Power Supply and Ground Circuit Inspection

1. Turn ignition switch ON.
2. Check voltage between power window and door lock/unlock switch RH connector D105 terminal 10 and ground.

   10 - Ground: Battery voltage 

Fig 1: Checking Voltage Between Power Window And Door Lock/Unlock Switch RH Connector Terminal 10 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: GO TO 2.

NG: Repair or replace harness.

1. Turn ignition switch OFF.
2. Disconnect front power window switch RH.
3. Check continuity between power window and door lock/unlock switch RH connector D105 terminal 11 and ground.

   11 - Ground: Continuity should exist. 

Fig 2: Checking Continuity Between Power Window And Door Lock/Unlock Switch RH Connector D105 Terminal 11 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: GO TO 3.

NG: Repair or replace harness.

1. Disconnect BCM and power window and door lock/unlock switch RH.
2. Check continuity between BCM connector and power window and door lock/unlock switch RH connectors.
   BCM CONNECTOR AND POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH
   
   

   Connector	Terminal	Connector	Terminal	Continuity
   A		B
   BCM: M20	69	Power window and door lock/unlock switch RH: D105	10	Yes

   Fig 3: Checking Continuity Between BCM Connector And Power Window And Door Lock/Unlock Switch RH Connectors

   Courtesy of NISSAN MOTOR CO., U.S.A.
3. Check continuity between BCM and ground.
   BCM AND GROUND
   
   

   Connector	Terminal	Ground	Continuity
   A
   BCM: M20	69		No

OK or NG 

OK: GO TO 4.

NG: Repair or replace harness.

1. Connect BCM.
2. Turn ignition switch ON.
3. Check voltage between BCM connector M20 terminal 69 and ground.

   69 - Ground: Battery voltage 

Fig 4: Checking Voltage Between BCM Connector M20 Terminal 69 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Replace power window and door lock/unlock switch RH.

Refer to "FRONT DOOR ".

NG: Replace BCM. Refer to "BCM ".