Rear Brake Piping and Hose: Installation
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Refill with new brake fluid. Refer to "RECOMMENDED FLUIDS AND LUBRICANTS ".
- Never reuse drained brake fluid.
- Attach the brake hose to the brake tube and temporarily tighten the flare nut as much as possible by hand.
- Attach the brake hose with a lock spring, then tighten the connecting bolt to the specified torque. Tighten the flare nut with a torque wrench to the specified torque. Refer to "HYDRAULIC CIRCUIT .
- Refill reservoir until new brake fluid comes out of each air bleeder valve.
- Bleed air from the brake system. Refer to "BLEEDING BRAKE SYSTEM .