1-2 Trunk Lamp And Trunk Release Solenoid Switch Check

With CONSULT-III 

Check ("TRUNK SW") in "DATA MONITOR" mode with CONSULT-III.

Without CONSULT-III 

1. Turn ignition switch OFF.
2. Check voltage between BCM harness connector M19 terminal 42 and ground.
   BCM HARNESS CONNECTOR M19 TERMINAL 42 AND GROUND
   
   

   Connector	Terminals		Trunk condition	Voltage (V) (Approx.)
   	(+)	(-)
   M19	42	Ground	CLOSE	Battery voltage
   			OPEN	0

   Fig 1: Checking Voltage Between BCM Harness Connector M19 Terminal 42 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Trunk lamp switch circuit is OK.

NG: GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect trunk lamp switch connector.
3. Check continuity between trunk lamp switch terminals 1 and 2.
   TRUNK LAMP SWITCH TERMINALS 1 AND 2
   
   

   Terminals		Trunk condition	Continuity
   1	2	Closed	No
   		Open	Yes

   Fig 2: Checking Continuity Between Trunk Lamp Switch Terminals 1 And 2

   Courtesy of NISSAN MOTOR CO., U.S.A.

   OK or NG 

   OK: GO TO 3.

   NG: Replace trunk lamp switch and trunk release solenoid.

1. Disconnect BCM connector M19.
2. Check continuity between BCM harness connector M19 terminal 42 and trunk lamp switch harness connector (B) T103 terminal 1.

   42 - 1: Continuity should exist. 

   Fig 3: Checking Trunk Lamp Switch Circuit

   Courtesy of NISSAN MOTOR CO., U.S.A.
3. Check continuity between BCM harness connector (A) M19 terminal 42 and ground.

   42 - Ground: Continuity should not exist. 

OK or NG 

OK: GO TO 4.

NG: Repair or replace harness between BCM and trunk lamp switch.

Check continuity between trunk lamp switch harness connector T103 terminal 2 and ground.

2 - Ground: Continuity should exist. 

Fig 4: Checking Continuity Between Trunk Lamp Switch Harness Connector T103 Terminal 2 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Check connection of harness and connector.

NG: Repair or replace trunk lamp switch ground circuit.