LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 933 (Exterior & Interior) >> Headlining >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Disconnect both cables from battery and wait at least 3 minutes.
  1. Disconnect the negative and positive battery cables, then wait at least 3 minutes.
  2. Remove front and rear door kicking plates. Refer to "BODY SIDE TRIM ".
  3. Remove lower dash side trim. Refer to "BODY SIDE TRIM ".
  4. Remove front pillar garnish, center pillar lower and upper garnish, and rear pillar garnish. Refer to "BODY SIDE TRIM ".
  5. Remove front and rear door welts. Refer to "BODY SIDE TRIM ".
  6. Remove assist grips.
  7. Remove interior lamp assembly.
  8. Remove roof console assembly.
  9. Remove RH and LH caps from sunvisor brackets.
  10. Remove screws from each sunvisor bracket and remove RH and LH sunvisor.
  11. Remove sunvisor assembly holders.
  12. Remove windshield garnish molding. Refer to "BODY SIDE TRIM ".
  13. Remove clips attaching headlining to roof.
  14. Take out headlining from the left rear door.
scientia non olet · About LEMON Manuals