LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 931 (Engine Cooling System) >> Water Outlet And Water Piping >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain coolant from drain plugs on radiator and both sides of cylinder block. Refer to "DRAINING ENGINE COOLANT ."
    CAUTION: Perform when the engine is cold.
  2. Remove engine cover using power tool.
  3. Remove air duct and air cleaner case assembly. Refer to "REMOVAL AND INSTALLATION ."
  4. Remove radiator upper hose and heater hose.
  5. Remove connector(s) from heater pipe.
  6. Disconnect engine coolant temperature sensor electrical connector on water outlet.
  7. Remove water outlet, heater pipe, water connector, and water bypass pipe nuts and bolts.
scientia non olet · About LEMON Manuals