Removal and Installation: Installation

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal, paying attention to the following:

NOTE: After installation, it is necessary to re-calibrate the electric throttle control actuator as follows:

Perform the "Throttle Valve Closed Position Learning" when harness connector of the electric throttle control actuator is disconnected. Refer to "THROTTLE VALVE CLOSED POSITION LEARNING ".
Perform the "Idle Air Volume Learning" when the electric throttle control actuator is replaced. Refer to "IDLE AIR VOLUME LEARNING ".
- If necessary, install power valve bolts in the order as shown.
  CAUTION: Do not reuse gasket.
  
  Fig 1: Identifying Power Valve Bolts
  Courtesy of NISSAN MOTOR CO., U.S.A.
- If necessary, tighten the intake manifold collector pipe bolts in the order as shown.
  CAUTION: Do not reuse gasket.
  
  Fig 2: Identifying Intake Manifold Collector Pipe Bolts With Tightening Sequence
  Courtesy of NISSAN MOTOR CO., U.S.A.
- If necessary, install the electric throttle control actuator bolts in the order as shown. Install gasket with three protrusions facing down.
  CAUTION: Do not reuse gasket.
  
  Fig 3: Identifying Electric Throttle Control Actuator Bolts
  Courtesy of NISSAN MOTOR CO., U.S.A.
- Install the intake manifold collector (lower) bolts in the order as shown.
  CAUTION: Do not reuse gasket.
  
  Fig 4: Identifying Intake Manifold Collector (Lower) Bolts With Tightening Sequence
  Courtesy of NISSAN MOTOR CO., U.S.A.