CAN Diagnostic Support Monitor: BCM
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replace the unit when "NG" is indicated on the "INITIAL DIAG".
BCM DESCRIPTION REFERENCE
| SELECT SYSTEM | CAN DIAG SUPPORT MNTR | Description | Normal | Error |
|---|---|---|---|---|
| PRSNT | ||||
| BCM | INITIAL DIAG | Status of CAN controller | OK | NG |
| TRANSMIT DIAG | Signal transmission status | UNKWN | ||
| ECM | Signal receiving status from the ECM | |||
| IPDM E/R | Signal receiving status from the IPDM E/R | |||
| METER/M&A | Signal receiving status from the unified meter and A/C amp. | |||
| I-KEY | Not used even though indicated | |||