Systems Controlled By IPDM E/R
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Lamp control
Using CAN communication lines, it receives signal from BCM and controls the following lamps:
- Head lamps (High, Low)
- Parking lamps
- Tail lamps
- License plate lamps
- Cornering lamps
- Front fog lamps
- Daytime light system (Canada only)
- Wiper control
Using CAN communication lines, it receives signals from the BCM and controls the front wipers.
- Rear window defogger relay control
Using CAN communication lines, it receives signals from the BCM and controls the rear window defogger relay.
- A/C compressor control
Using CAN communication lines, it receives signals from the ECM and controls the A/C compressor (magnet clutch).
- Starter control
Using CAN communication lines, it receives signals from the BCM and controls the starter relay.
- Cooling fan control
Using CAN communication lines, it receives signals from the ECM and controls the cooling fan relays.
- Horn control
Using CAN communication lines, it receives signals from the BCM and controls the horn relay.