Inspection Flow

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CONFIRM SYMPTOM BY PERFORMING OPERATIONAL CHECK - TEMPERATURE INCREASE
1. Turn the temperature control dial (driver) clockwise until 32°C (90°F) is displayed.
2. Check for hot air at discharge air outlets.
  : GO TO 2.
CONFIRM SYMPTOM BY PERFORMING OPERATIONAL CHECK - TEMPERATURE DECREASE
1. Turn the temperature control dial (driver) counterclockwise until 16°C (60°F) is displayed.
2. Check for cold air at discharge air outlets.
Can a symptom be duplicated?

Yes: GO TO 4.

No: GO TO 3.
PERFORM COMPLETE OPERATIONAL CHECK
Perform a complete operational check and check for any symptoms. Refer to "OPERATIONAL CHECK ".

Can a symptom be duplicated?

YES: Refer to "SYMPTOM TABLE ".

NO: System OK.
CHECK FOR SERVICE BULLETINS
Check for any service bulletins.

: GO TO 5.
PERFORM FRONT AIR CONTROL SELF-DIAGNOSIS
Perform front air control self-diagnosis. Refer to "FRONT AIR CONTROL SELF - DIAGNOSIS ".

OK or NG

OK: GO TO 6.

NG: Perform power and ground circuit for front air control. Refer to "POWER SUPPLY AND GROUND CIRCUIT FOR FRONT AIR CONTROL AND UNIFIED METER AND A/C AMP .".
PERFORM SELF-DIAGNOSIS STEP - 2
Perform self-diagnosis STEP - 2. Refer to "FUNCTION CONFIRMATION PROCEDURE ".

OK or NG

OK: GO TO 7.

OK: Perform appropriate malfunctioning sensor circuit.
PERFORM SELF-DIAGNOSIS STEP - 4
Perform self-diagnosis STEP - 4. Refer to "FUNCTION CONFIRMATION PROCEDURE ".

OK and NG

OK: GO TO 8.

NG: Check LAN system circuit. Refer to "LAN SYSTEM CIRCUIT ".
CHECK AMBIENT SENSOR CIRCUIT (CAUSE CANNOT BE CONFIRMED BY SELF-DIAGNOSIS)
Perform diagnostic procedure for the ambient sensor circuit. Refer to "AMBIENT SENSOR CIRCUIT ".

OK or NG

OK: GO TO 9.

NG: Repair as necessary.
CHECK IN-VEHICLE SENSOR CIRCUIT
Perform diagnostic procedure for the in-vehicle sensor circuit. Refer to "IN-VEHICLE SENSOR CIRCUIT ".

OK or NG

OK: GO TO 10.

NG: Repair as necessary.
CHECK SUNLOAD SENSOR CIRCUIT
Perform diagnostic procedure for the sunload sensor circuit. Refer to "SUNLOAD SENSOR CIRCUIT ".

OK or NG

OK: GO TO 11.

NG: Repair as necessary.
CHECK INTAKE SENSOR CIRCUIT
Perform diagnostic procedure for the intake sensor circuit. Refer to "INTAKE SENSOR CIRCUIT ".

OK or NG

OK: GO TO 12.

NG: Repair as necessary.
CHECK AIR MIX DOOR MOTOR PBR CIRCUIT
Perform diagnostic procedure for the air mix door motor circuit. Refer to "AIR MIX DOOR MOTOR CIRCUIT ".

OK or NG

OK: If the symptom still exists, perform a complete operational check. Refer to "OPERATIONAL CHECK " and check for other symptoms. Refer to "SYMPTOM TABLE ". If no other symptom exists, replace unified meter and A/C amp. Refer to "UNIFIED METER AND A/C AMP .".

NG: Repair as necessary.