Removal and Installation for Compressor Clutch: Installation

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Install the magnet coil.
CAUTION: Be sure to align the magnet coil pin with the hole in the compressor front head.
Install the magnet coil harness clip using a screwdriver.

Fig 1: Aligning Magnet Coil Pin With Hole In Compressor Front Head
Courtesy of NISSAN MOTOR CO., U.S.A.
Install the pulley assembly using Tool and a wrench, and then install the snap ring using snap ring pliers.
Tool number: - (J-38873-A)

Fig 2: Identifying Magnet Coil Harness Clip
Courtesy of NISSAN MOTOR CO., U.S.A.
Install the clutch disc on the drive shaft, together with the original shim(s). Press the clutch disc down using the drive plate installer.

Fig 3: Identifying Clutch Disc
Courtesy of NISSAN MOTOR CO., U.S.A.
Install the center bolt using Tool.
Center bolt: 21 N.m (2.1 kg-m, 15 ft-lb)

Tool number: (J-44614)
- After tightening the center bolt to specification, check that the pulley rotates smoothly.
Fig 4: Identifying Clutch Disc Holding Tool
Courtesy of NISSAN MOTOR CO., U.S.A.