LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 922 (Continuously Variable Transmission (CVT)) >> Trouble Diagnosis >> Inspections before Trouble Diagnosis >> Stall Test >> Stall Test Procedure

Stall Test Procedure

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the amount of engine oil. Replenish the engine oil if necessary.
  2. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50° - 80°C (122° - 176°F). Inspect the amount of CVT fluid. Replenish if necessary.
    Fig 1: Checking A/T Fluid Temperature
    G04875842Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Securely engage the parking brake so that the tires do not turn.
  4. Install a tachometer where it can be seen by driver during test.
    • It is good practice to mark the point of specified engine rpm on indicator.
  5. Start engine, apply foot brake, and place selector lever in "D" position.
    Fig 2: Engaging Parking Brake
    G04875847Courtesy of NISSAN MOTOR CO., U.S.A.
  6. While holding down the foot brake, gradually press down the accelerator pedal.
  7. Quickly read off the stall speed, and then quickly remove your foot from the accelerator pedal.
    CAUTION: Do not hold down the accelerator pedal for more than 5 seconds during this test.

    Stall speed: 2,700 - 3,250 rpm 

  8. Move the selector lever to the "N" position.
  9. Cool down the CVT fluid.
    Fig 3: Identifying Accelerator Pedal Position
    G04875844Courtesy of NISSAN MOTOR CO., U.S.A.
    CAUTION: Run the engine at idle for at least 1 minute.
  10. Repeat steps  6 through  9 with selector lever in "R" position.
scientia non olet · About LEMON Manuals