LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 922 (Continuously Variable Transmission (CVT)) >> DTC P0778 Pressure Control Solenoid B Electrical (Sec Pressure Solenoid Valve) >> Component Inspection >> Pressure Control Solenoid Valve B (Secondary Pressure Solenoid Valve)

Pressure Control Solenoid Valve B (Secondary Pressure Solenoid Valve)

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF.
  2. Disconnect CVT unit harness connector.
  3. Check resistance between CVT unit harness connector terminal and ground.
    PRESSURE CONTROL SOLENOID VALVE B (SECONDARY PRESSURE SOLENOID VALVE)

    Solenoid Valve Connector Terminal Resistance (Approx.)
    Pressure control solenoid valve B (Secondary pressure solenoid valve) F30 3 - Ground 3.0 - 9.0 Ω
    Fig 1: Checking Resistance Between CVT Unit Harness Connector Terminal And Ground
    G04916131Courtesy of NISSAN MOTOR CO., U.S.A.
  4. If NG, replace the transaxle assembly. Refer to "REMOVAL AND INSTALLATION ".
scientia non olet · About LEMON Manuals