LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 922 (Continuously Variable Transmission (CVT)) >> DTC P0725 Engine Speed Signal >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be careful not to rev engine into the red zone on the tachometer.
NOTE: If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

After the repair, touch "ERASE" on "SELF-DIAG RESULTS" and then perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-III 

  1. Turn ignition switch ON and select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
  2. Start engine and maintain the following conditions for at least 10 consecutive seconds.

    PRI SPEED SEN: More than 1000 rpm 

  3. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About LEMON Manuals