Check SRS Intermittent Malfunction Using CONSULT-III-Diagnosis Mode

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Refer to "CONSULT-III START PROCEDURE ".

If diagnostic codes are displayed on "SELF-DIAG [PAST]", go to step 4.

Fig 1: CONSULT-III Function Screen Display - SELF-DIAG (PAST)
Courtesy of NISSAN MOTOR CO., U.S.A.

If no malfunction is detected on "SELF-DIAG [PAST]", touch "BACK" and go back to "SELECT DIAG MODE".

Fig 2: CONSULT-III Function Screen Display - SELF-DIAG (PAST)
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "TROUBLE DIAG RECORD".
NOTE: With "TROUBLE DIAG RECORD", diagnosis results previously erased by a reset operation can be displayed.

Fig 3: CONSULT-III Function Screen Display - SELECT DIAG MODE
Courtesy of NISSAN MOTOR CO., U.S.A.
Diagnostic code is displayed on "TROUBLE DIAG RECORD".
Touch "PRINT".
Compare diagnostic codes to "CONSULT-III DIAGNOSTIC CODE CHART ("SELF-DIAG [PAST]" OR "TROUBLE DIAG RECORD") ".
Touch "BACK" key of CONSULT-III until "SELECT SYSTEM" appears.
Turn ignition switch OFF, then turn off and disconnect CONSULT-III, and both battery cables.
Repair the system as outlined by the "Repair order" in "Intermittent Malfunction Diagnostic Code Chart", that corresponds to the self-diagnostic result. For replacement procedure of component parts, refer to the Removal and Installation procedure for the appropriate component.
Go to "DIAGNOSTIC PROCEDURE 3 ", for final checking.

Fig 4: CONSULT-III Function Screen Display - TROUBLE DIAG RECORD
Courtesy of NISSAN MOTOR CO., U.S.A.