Diagnostic Procedure 2

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Refer to "CONSULT-III START PROCEDURE ".

Diagnostic code is displayed on "SELF-DIAG [CURRENT]".

If no malfunction is detected on "SELF-DIAG [CURRENT]" even though malfunction is detected in "SRS Operation Check", refer to "DIAGNOSTIC PROCEDURE 4 (CONTINUED FROM DIAGNOSTIC PROCEDURE 2) ", to diagnose the following cases:

Self-diagnostic result "SELF-DIAG [PAST]" (previously stored in the memory) might not be erased after repair.
The SRS system malfunctions intermittently.