Height Difference Adjustment
WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Tilt glass lid assembly up and down.
- Check height difference between roof panel and glass lid assembly; compare to "A-A" and "B-B" (when sunroof is closed) as shown in the figure.
- If necessary, adjust height difference by using one of the following procedures:
- Adjust by adding or removing adjustment shim(s) between the glass lid assembly and sunroof frame assembly.
- If glass lid assembly protrudes above roof panel, add shim(s) or plain washers at sunroof bracket locations to meet height specifications as shown in figure.
- Tighten glass lid assembly screws and sunroof bracket bolts as required.
NOTE: First tighten center front screw, then right rear on glass lid assembly to prevent movement while tightening other screws.