LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 917 (Seat Belts) >> Seat Belts >> Removal and Installation of Front Seat Belt >> Seat Belt Retractor >> Removal

Seat Belt Retractor: Removal

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative and positive battery cables, then wait at least 3 minutes.
  2. Remove the adjuster cover on the seat belt anchor.
    Fig 1: Identifying Seat Belt Retractor
    G04916633Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Remove the anchor bolts.
  4. Remove the center pillar upper/lower garnish. Refer to "REMOVAL AND INSTALLATION ".
  5. Remove the anchor bolt.
    • For front passenger side, disconnect belt tension sensor.
  6. Disconnect the seat belt pre-tensioner connector.
  7. Remove the seat belt pre-tensioner retractor screw and anchor bolt, then remove the seat belt retractor.
    Fig 2: Seat Belt Pre-Tensioner Retractor Screw And Anchor Bolt With Torque Specifications
    G04916634Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals