LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 916 (SRS Airbag) >> Crash Zone Sensor >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative and positive battery cables, then wait at least 3 minutes.
  2. Remove front grille. Refer to "REMOVAL AND INSTALLATION ".
  3. Disconnect crash zone sensor harness connector.
  4. Remove crash zone sensor nuts.
    Fig 1: Crash Zone Sensor Nuts With Torque Specifications
    G04916704Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals