LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 912 (Exterior & Interior) >> Rear Parcel Shelf Finisher >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative and positive battery cables, then wait at least 3 minutes.
  2. Remove rear seat. Refer to "REAR SEAT ".
  3. Remove rear seat belt anchor bolts. Refer to "REMOVAL AND INSTALLATION OF REAR SEAT BELT ".
  4. Remove inside rear pillar finisher. Refer to "BODY SIDE TRIM ".
  5. Remove the high mounted stop lamp, then disconnect connector (if equipped).
  6. Remove halo trim.
  7. Remove rear parcel shelf finisher.
    Fig 1: Identifying Hooks And Pawls
    G04917286Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals