LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 912 (Exterior & Interior) >> Rear Bumper >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove rear trunk plate, then partially remove trunk side finishers. Refer to "TRUNK ROOM TRIM & TRUNK LID FINISHER ".
  2. Remove rear combination lamp RH/LH. Refer to "REAR COMBINATION LAMP ".
  3. Disconnect sonar sensor harness connector (if equipped)
  4. Remove rear bumper fascia.
    • If fascia is to be replaced, remove bracket from fascia.
  5. Remove energy absorber from rear bumper reinforcement.
  6. Remove rear bumper reinforcement.
scientia non olet · About LEMON Manuals