Removal and Installation: Notes

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

When removing or installing body side welts, do not allow butyl seal to come in contact with pillar garnish.
Insert screw driver rolled with cloth between panel on vehicle and clips (as indicated with arrow), and disconnect clips.

Fig 1: Identifying Door Body Panel Clips

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Identifying Body Side Trim Components

Courtesy of NISSAN MOTOR CO., U.S.A.