Power Seat Switch LH Ground Inspection

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK POWER SEAT SWITCH LH GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect power seat switch LH.
3. Check continuity between power seat switch LH connector B408 terminal 7 and ground.
  7 - Ground: Continuity should exist.
Fig 1: Checking Continuity Between Power Seat Switch LH Connector B408 Terminal 7 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Check the condition of the harness and connector.

NG: Repair or replace harness.