Front Door Switch LH Circuit Inspection

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DOOR SWITCH INPUT SIGNAL

With CONSULT-II

Check door switch ("DOOR SW-DR") in "DATA MONITOR" mode with CONSULT-II.

MONITOR ITEM CHART

Monitor item	Condition
DOOR SW-DR	OPEN: ON
DOOR SW-DR	CLOSE: OFF

Fig 1: CONSULT-II Display - DATA MONITOR

Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II

Check voltage between BCM connector and ground.

VOLTAGE CHART

Item	Connector	Terminals		Condition	Voltage (V) (Approx.)
Item	Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
Front door switch LH	M19	47	Ground	OPEN	0
Front door switch LH	M19	47	Ground	CLOSE	Battery voltage

Fig 2: Checking Voltage Between BCM Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Front door switch LH is OK.

NG: GO TO 2.

CHECK FRONT DOOR SWITCH LH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect front door switch LH and BCM.
3. Check continuity between front door switch LH connector B8 terminal 2 and BCM connector M19 terminal 47.
  2 - 47: Continuity should exist.
4. Check continuity between door switch LH connector B8 terminal 2 and ground.
  2 - Ground: Continuity should not exist.
Fig 3: Checking Continuity Between Front Door Switch LH Terminal 2 And BCM Terminal 47
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 3.

NG: Repair or replace harness.

CHECK FRONT DOOR SWITCH LH

Check continuity between front door switch LH terminal 2 and body ground part of door switch.

FRONT DOOR SWITCH LH

Terminal		Door switch	Continuity
2	Body ground part of door switch	Pushed	No
2	Body ground part of door switch	Released	Yes

Fig 4: Checking Continuity Between Door Switch Terminal 2 And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Further inspection is necessary. Refer to SYMPTOM CHART .

NG: Replace front door switch LH.