Door Mirror Remote Control Switch Ground Circuit Check

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT
Check continuity between door mirror remote control switch connector M7 terminal 13 and ground.

13 - Ground: Continuity should exist.

Fig 1: Checking Continuity Between Door Mirror Remote Control Switch Connector M7 Terminal 13 And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 2.

NG: Repair or replace harness.

CHECK DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT

Check continuity between door mirror remote control switch terminals as follows.

DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT

Terminals		Condition	Continuity
3	13	Changeover switch RIGHT position	Yes
3		Other than above	No
2		Changeover switch LEFT position	Yes
2		Other than above	No

Fig 2: Checking Continuity Between Door Mirror Remote Control Switch Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Check the condition of the harness and the connector.

NG: Replace door mirror remote control switch.