Headlamp LH Low Beam and High Beam Does Not Illuminate

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK BULB
Inspect ballasts (HID control unit) and xenon bulb of lamp which does not illuminate. Refer to "XENON HEADLAMP TROUBLE DIAGNOSIS ".

OK or NG

OK: GO TO 2.

NG: Repair malfunctioning part.
CHECK HEADLAMP GROUND
1. Disconnect front combination lamp LH connector.
2. Check continuity between front combination lamp LH harness connector E11 terminal 4, 8 and ground.
  4, 8 - Ground: Continuity should exist.
Fig 1: Checking Continuity Between Front Combination Lamp LH Connector E11 Terminal 4, 8 And Ground

OK or NG

OK: GO TO 3.

NG: Repair harness or connector.
CHECK HEADLAMP CIRCUIT
1. Disconnect IPDM E/R connector.
2. Check continuity between IPDM E/R harness connector E122 terminal 28 and front combination lamp LH harness connector E11 terminal 7.
  28 - 7: Continuity should exist.
  
  Fig 2: Checking Continuity Between IPDM E/R E122 Terminal 28 And Front Combination Lamp LH Harness Connector E11 Terminal 7
3. Check continuity between IPDM E/R harness connector E122 terminal 30 and front combination lamp LH harness connector E11 terminal 3.
  30 - 3: Continuity should exist.
Fig 3: Checking Continuity Between IPDM E/R E122 Terminal 30 And Front Combination Lamp LH Harness Connector E11 Terminal 3

OK or NG

OK: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".

NG: Repair harness or connector.