LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 908 (Lighting System) >> Headlamp (For CANADA) - Daytime Light System - >> Preliminary Check >> Inspection Parking Brake Switch Circuit

Inspection Parking Brake Switch Circuit

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK BRAKE INDICATOR 
    1. Turn ignition switch ON.
    2. Apply parking brake.
    3. Release parking brake.

      Brake indicator in combination meter should illuminate when parking brake is applied and turn OFF when released. 

    OK or NG 

    OK: Inspection End.

    NG: GO TO 2.

  2. CHECK PARKING BRAKE SWITCH SIGNAL 
    1. Turn ignition switch OFF.
    2. Disconnect parking brake switch connector.
    3. Turn ignition switch ON.
    4. Check voltage between parking brake switch harness connector M36 terminal 1 and ground.

      1 - Ground: Battery voltage should exist. 

    Fig 1: Checking Voltage Between Parking Brake Switch Connector M36 Terminal 1 And Ground
    G04903618

    OK or NG 

    OK: Replace parking brake switch.

    NG: GO TO 3.

  3. CHECK PARKING BRAKE SWITCH CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect combination meter connector.
    3. Check continuity between combination meter harness connector M24 (A) terminal 16 and parking brake switch harness connector M36 (B) terminal 1.

      1 - 16: Continuity should exist. 

    Fig 2: Checking Continuity Between Combination Meter Harness Connector M24 Terminal And Parking Brake Switch Harness Connector M36
    G04917839

    OK or NG 

    OK: Replace combination meter. Refer to "COMBINATION METER ".

    NG: Repair harness or connector.

scientia non olet · About LEMON Manuals