Front Fog Lamp Does Not Illuminate (One Side)

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK BULB
Check bulb of lamp which does not illuminate.

OK or NG

OK: GO TO 2.

NG: Replace front fog lamp bulb. Refer to "BULB REPLACEMENT ".
CHECK FOG LAMP CIRCUIT
1. Disconnect IPDM E/R connector and front fog lamp RH or LH connector.
2. Check continuity between IPDM E/R connector E124 (A) terminal 36 and front fog lamp RH connector E102 (B) terminal 1.
  36 - 1: Continuity should exist.
3. Check continuity between IPDM E/R connector E124 (A) terminal 37 and front fog lamp LH connector E101 (B) terminal 1.
  37 - 1: Continuity should exist.
Fig 1: Checking Continuity Between IPDM E/R Connector E124 Terminal 37 And Front Fog Lamp LH Connector E101 Terminal 1

OK or NG

OK: GO TO 3.

NG: Repair harness or connector.
CHECK FOG LAMP GROUND
1. Check continuity between front fog lamp RH harness connector E102 terminal 2 and ground.
  2 - Ground: Continuity should exist.
2. Check continuity between front fog lamp LH harness connector E101 terminal 2 and ground.
  2 - Ground: Continuity should exist.
  
  Fig 2: Checking Continuity Between Front Fog Lamp LH Harness Connector E101 Terminal 2 And Ground
OK or NG

OK: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION OF IPDM E/R ".

NG: Repair harness or connector.