LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 905 (Brake System) >> Brake Booster >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Be careful not to deform or bend brake piping while removing and installing the brake booster.
  • Replace clevis pin if it is damaged.
  • Be careful not to damage brake booster stud bolt threads. If brake booster is tilted or inclined during installation, the dash panel may damage the threads.
  • Attach the check valve in the correct orientation.
  1. Remove the brake master cylinder. Refer to "REMOVAL AND INSTALLATION .
  2. Remove vacuum hose from the brake booster. Refer to "REMOVAL AND INSTALLATION .
  3. Remove lower driver instrument panel. Refer to "LOWER DRIVER INSTRUMENT PANEL ".
  4. Remove the brake pedal attachment snap pin and clevis pin from inside the vehicle.
  5. Remove the nuts on the brake booster and brake pedal assembly.
  6. Remove brake booster assembly from the engine compartment side.
scientia non olet · About LEMON Manuals