CVT Indicator Does Not Illuminate

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK SELF-DIAGNOSIS OF COMBINATION METER
Perform combination meter self-diagnosis. Refer to "OPERATION PROCEDURE ".

Fig 1: Identifying Segments Of CVT Indicator
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 2.

NG: Replace combination meter. Refer to "COMBINATION METER ".
CHECK SELF-DIAGNOSIS RESULTS OF UNIFIED METER AND A/C AMP.
1. Start engine.
2. Select "METER A/C AMP" on CONSULT-II, and perform self-diagnosis of unified meter and A/C amp. Refer to "SELF-DIAGNOSTIC RESULTS ".
3. After erasing the self-diagnosis result, perform self-diagnosis again.
Self-diagnosis results content

No malfunction detected: GO TO 3.

Malfunction detected: GO TO "DISPLAY ITEM LIST ".

CHECK UNIFIED METER AND A/C AMP. INPUT SIGNAL

Lift drive wheels.
Connect CONSULT-II and start engine.
Select "DATA MONITOR" of "METER A/C AMP". Confirm each indication on the monitor when operating the shift lever.

UNIFIED METER AND A/C AMP. INPUT SIGNAL

CONSULT-II display	Switch operation	Operation status
AT-M GEAR	Manual mode range (shift up or down)	6-1
AT-M GEAR	Except for manual mode range	1
P RANGE IND	P range position	ON
P RANGE IND	Except for P range position	OFF
R RANGE IND	R range position	ON
R RANGE IND	Except for R range position	OFF
N RANGE IND	N range position	ON
N RANGE IND	Except for N range position	OFF
D RANGE IND	D range position	ON
D RANGE IND	Except for D range position	OFF

Fig 2: CONSULT-II DATA MONITOR Screen

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Replace combination meter. Refer to "COMBINATION METER "

NG: GO TO 4.

CHECK TCM
Perform self-diagnosis of TCM. Refer to "SELF-DIAGNOSTIC RESULT MODE ".

OK or NG

OK: Replace the unified meter and A/C amp. Refer to "UNIFIED METER AND A/C AMP. ".

NG: Check the applicable parts.