Inspection Procedure

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the unified meter and A/C amp. for damage, bend and loose connection (unit side and connector side).
OK or NG

OK: GO TO 2.

NG: Repair the terminal and connector.

CHECK HARNESS FOR OPEN CIRCUIT

Disconnect the connector of unified meter and A/C amp.
Check the resistance between the unified meter and A/C amp. harness connector terminals.

HARNESS FOR OPEN CIRCUIT

Unified meter and A/C amp. harness connector			Resistance (Ω)
Connector No.	Terminal No.		Resistance (Ω)
M49	1	11	Approx. 54 - 66

OK or NG

OK: GO TO 3.

NG: Repair the unified meter and A/C amp. branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the unified meter and A/C amp. Refer to "SCHEMATIC ".

OK or NG

OK:
- Present error: Replace the unified meter and A/C amp. Refer to "UNIFIED METER AND A/C AMP. ".
- Past error: Error was detected in the unified meter and A/C amp. branch line.
NG: Repair the power supply and the ground circuit.