LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 901 (LAN System) >> Can >> Trouble Diagnosis >> CAN Diagnostic Support Monitor >> ABS actuator and electric unit (control unit)

ABS actuator and electric unit (control unit)

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Models with VDC 

MODELS WITH VDC REFERENCE CHART

SELECT SYSTEM CAN DIAG SUPPORT MNTR Description Normal Error
PRSNT
ABS INITIAL DIAG Status of CAN controller OK NG(1)
TRANSMIT DIAG Signal transmission status UNKWN
ECM Signal receiving status from the ECM
TCM Signal receiving status from the TCM
METER/M&A Not used even though indicated
STRG Signal receiving status from the steering angle sensor OK UNKWN
ICC Not used even though indicated
CAUTION:
(1) Never replace the unit even when "NG" is indicated on the "INITIAL DIAG" at this stage. Follow the trouble diagnosis procedures.
scientia non olet · About LEMON Manuals