Consult-II Start Procedure

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.

Turn ignition switch OFF.
Insert NVIS (NATS) program card into CONSULT-II.
Program card: NATS (AEN04A-1) or later
Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.

Fig 1: Identifying Hood Opener Handle And Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch ON.
Touch "START".

Fig 2: Identifying CONSULT-II Display - START
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "OTHER".

Fig 3: Identifying CONSULT-II Display -- OTHER
Courtesy of NISSAN MOTOR CO., U.S.A.
Select "NATS V.5.0".
If "NATS V5.0" is not indicated, go to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

Fig 4: CONSULT-II Display - SELECT SYSTEM
Courtesy of NISSAN MOTOR CO., U.S.A.
Perform each diagnostic test mode according to each service procedure.

For further information, see the CONSULT-II Operation Manual NATS-IVIS/NVIS.

Fig 5: CONSULT-II Display - SELECT DIAG MODE

Courtesy of NISSAN MOTOR CO., U.S.A.