"P-SHIFT" Warning Lamp Check

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK WARNING LAMP OPERATION
With CONSULT-II
- Check "INDICATOR" in "ACTIVE TEST" mode with CONSULT-II.
- Select "KNOB ON".
"P-SHIFT" warning lamp should illuminate.

Fig 1: CONSULT-II Display - ACTIVE TEST
Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II
1. Turn ignition switch OFF.
2. While monitoring the combination meter warning lamps, turn ignition switch ON. "P-SHIFT" warning lamp should illuminate for 1 second to perform a bulb check.
Fig 2: Identifying Combination Meter Warning Lamps
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: INSPECTION END

NG: Check combination meter. Refer to "COMBINATION METERS ".