Consult-II Operation Procedure

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which performs CAN communication.

Using CONSULT-II, perform a cruise test and record the result.
Print the result and ensure that shifts and lock-ups take place as per Shift Schedule.

Touch "DATA MONITOR" on "SELECT DIAG MODE" screen.

Fig 1: CONSULT-II Display - SELECT DIAG MODE
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "MAIN SIGNALS" to set recording condition.
See "Numerical Display", "Barchart Display" or "Line Graph Display".
Touch "START".

Fig 2: CONSULT-II Display - MAIN SIGNAL
Courtesy of NISSAN MOTOR CO., U.S.A.
When performing cruise test. Refer to "CRUISE TEST ."
After finishing cruise test part, touch "RECORD".

Fig 3: CONSULT-II Display - DATA MONITOR
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "STORE".

Fig 4: CONSULT-II Display - REAL TIME DIAG
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BACK".

Fig 5: CONSULT-II Display - STORE DATA
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "DISPLAY".

Fig 6: CONSULT-II Display - REAL TIME DIAG
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "PRINT".
Check the monitor data printed out.

Fig 7: CONSULT-II Display - MONITOR DATA PRINTED OUT
Courtesy of NISSAN MOTOR CO., U.S.A.