LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 896 (Continuously Variable Transmission (CVT)) >> Trouble Diagnosis >> CONSULT-II Function (TRANSMISSION) >> Work Support Mode >> Engine Brake Adjustment

Engine Brake Adjustment

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Touch "WORK SUPPORT" on "SELECT DIAG MODE" screen.
    Fig 1: CONSULT-II Display - SELECT DIAG MODE
    G04899604Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Touch "ENGINE BRAKE ADJ".
    Fig 2: CONSULT-II Display - SELECT WORK ITEM
    G04916034Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Touch "START".
    Fig 3: CONSULT-II Display - ENGINE BRAKE ADJUST
    G04916035Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Set "ENGINE BRAKE LEVEL" by touching "UP" or "DOWN".

    "ENGINE BRAKE LEVEL" 

    0: Initial set value (Engine brake level control is activated) 

    OFF: Engine brake level control is deactivated  .

  5. Turn ignition switch OFF, wait at least 5 seconds and then turn ignition switch ON.
  6. Engine brake level set is completed.
    CAUTION: Mode of "+1" "0" "-1" "-2" "OFF" can be selected by pressing the "UP" "DOWN" on CONSULT-II screen. However, do not select mode other than "0" and "OFF". If the "+1" or "-1" or "-2" is selected, that might cause the irregular driveability.
    Fig 4: CONSULT-II Screen Display - ADJUST MONITOR
    G04916036Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals