LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2004 >> Altima S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 896 (Continuously Variable Transmission (CVT)) >> Precautions >> Precautions for TCM and CVT Assembly Replacement >> Method For Erasing The EEPROM In The TCM

Method For Erasing The EEPROM In The TCM

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect CONSULT-II to data link connector. Refer to "CONSULT-II START PROCEDURE ".
  2. Turn ignition switch ON. Confirm that CONSULT-II is turned ON.
  3. Move selector lever to "R" position.
  4. Touch "START (NISSAN BASED VHCL)" on CONSULT-II.
  5. Select "SELF-DIAG RESULTS" mode for "TRANSMISSION" with CONSULT-II.
  6. Press the brake pedal and turn the brake switch ON.
  7. Press the accelerator pedal (0.5/8 - 4/8 throttle) not to exceed the half, and hold it in the half or less open position. (This will set the closed throttle position signal to OFF and the wide open throttle position signal to OFF.)
  8. Touch "ERASE" on CONSULT-II, and then touch "YES".
  9. Wait 3 seconds and then release the accelerator pedal.
  10. Turn ignition switch OFF.
scientia non olet · About LEMON Manuals