Check Battery Circuit
WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK BATTERY CIRCUIT CONNECTION
Check to see if "B" terminal is clean and tight.
OK or NG
OK: GO TO 2. Confirm repair by performing complete Battery/Starting/Charging system test.
NG: Repair terminal "B" connection.
- CHECK BATTERY CIRCUIT
Check voltage between generator connector F2 terminal B and ground using a digital circuit tester.
Courtesy of NISSAN MOTOR CO., U.S.A.
Battery voltage should exist.
OK or NG
OK: GO TO 3.
NG: Check the following.
- 120A fusible link (letter a , located in fusible link box)
- Harness for open or short between generator and fusible link
- CHECK VOLTAGE DROP ON BATTERY CIRCUIT
Check voltage between generator connector F2 terminal B and battery positive terminal using a digital tester.
Courtesy of NISSAN MOTOR CO., U.S.A.
With engine running at idle and warm: Less than 0.2V
OK or NG
OK: Replace the generator. Confirm repair by performing complete Battery/Starting/Charging system test.
NG: Check harness between the battery and the generator for poor continuity.