Removal and Installation: Installation
WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal.
- Install high and low pressure pipe connections to power steering gear. Refer to
"REMOVAL AND INSTALLATION ".CAUTION:
- Use the specified tightening torque when installing the high-pressure and low-pressure pipe connections. Excessive tightening will damage threads of connection or O-ring.
- The O-ring in low-pressure pipe connector is larger than that in high-pressure connector. Take care to install the proper O-ring.
- Initially, tighten nut on tie-rod outer socket and knuckle arm to specification. Then tighten further to align nut groove with first pin hole so that the cotter pin can be installed.
CAUTION:
Tightening torque must not exceed 49 N.m (5 kg-m, 36 ft-lb).