Inspection 1: Warning Lamp Does Not Come On When Ignition Switch Is Turned
WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC PROCEDURE
- SELF-DIAGNOSTIC RESULT CHECK
Using CONSULT-II, check display contents in self-diagnostic results.
Is "CAN COMM CIRCUIT" displayed in the self-diagnosis display items?
YES: Malfunction in CAN communication system. GO TO "TROUBLE DIAGNOSIS ".
NO: GO TO 2.
- CHECK COMBINATION METER
Check combination meter operation.
Inspection results OK?
OK: GO TO 3.
NG: Check combination meter. Refer to "SELF-DIAGNOSIS MODE OF COMBINATION METER ".
- CHECK LOW TIRE PRESSURE WARNING LAMP
Disconnect BCM harness connector.
Does the low tire pressure warning lamp activate?
YES: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".
NO: Check combination meter and repair or replace.