Malfunction Code No. 21, 22, 23, 24, DTC C1708, C1709, C1710 Or C1711

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONTROL UNIT
Drive for several minutes. Check all tire pressures with CONSULT-II "DATA MONITOR ITEM".

Are all tire pressures displayed as 0 kPa?

YES: GO TO 2.

NO: GO TO 3.
CHECK REMOTE KEYLESS ENTRY RECEIVER CONNECTOR
Check remote keyless entry receiver connector for damage or loose connections.

OK or NG

OK: Replace BCM, then GO TO 3. Refer to "REMOVAL AND INSTALLATION ".

NG: Repair or replace remote keyless entry receiver connector.
ID REGISTRATION
Carry out ID registration of all transmitters. Refer to "ID REGISTRATION PROCEDURE ".

Is there a tire that cannot register ID?

YES: Replace transmitter of the tire, then GO TO 5. Refer to "TRANSMITTER (PRESSURE SENSOR) ".

NO: GO TO 4.
VEHICLE DRIVING
1. Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
2. Check all tire pressures with CONSULT-II "DATA MONITOR ITEM" within 15 minutes after vehicle speed becomes 17 km/h (11 MPH).
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?

YES: Inspection End.

NO: GO TO 5.
ID REGISTRATION AND VEHICLE DRIVING
1. Carry out ID registration of all transmitters. Refer to "ID REGISTRATION PROCEDURE ".
2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
3. Check all tire pressures with CONSULT-II "DATA MONITOR ITEM" within 5 minutes.
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?

YES: Inspection End.

NO: GO TO the inspection applicable to DTC.